HP 8360 L Series User Manual page 295

S-38 Operating and Programming Reference
POWer:OFFSet <num>~DBllMAXimumlMINimumlUPlDOWN
l
l
Sets and queries the power offset,. This function changes mapping of
absolute power parameters on input to and output from the swept
CW generator. Changing this does not, affect the output power of
the swept CW generator. Only the displayed parameters and query
responses are changed. The equation implied by this is:
The entered or displayed power = Hardware Power + Offset After
POWer:OFFSet:STATe ONlOFFlllO
l
Queries and turns the power offset off and on. After *RST, the
setting is OFF.
POWer:RANGe <num>[lvl suffix] lMAXimumlMINimumlUPlDOWN
l
POWer:RANGe?
l
Sets and queries the setting of the power meter range. This is used
when the command POWer:ALC:SOURceis set to PMETer.
POWer:SEARch ONlOFFlllOlONCE
l
POWer:SEARch?
l
Sets and queries the power search switch. This has an interaction
with
P O W e r : A L C : S T A T e
ON ON
OFF
ON
ON O N C E
OFF not applicable
POWer:SLOPe <num>CDB/freq
l
POWer:SLOPe? CMAXimumlMINimuml
l
Sets and queries the RF slope setting (dB per Hz).
FREQ:MODE Affect on Slope
Rotates around 0 Hz.
CW or LIST
Rotates around the start frequency.
STEP
as described below.
P O W e r : S E A R c h
ALC is momentarily closed to
level at the requested power,
and then the modulator is set to
the same voltage in open loop
mode. This repeats automatically
any time that the power level or
frequency is changed.
Normal mode.
Immediately performs a power
search. This leaves POWer:SEARch
in the ON position.
Modulator setting is
explicitly set by user.
Power Switch Action