Smartport
Error Handling
Error Handling
Default Configuration
Relationships with Other Features
Common Smartport Tasks
STEP 1
STEP 2
STEP 3
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
When a smart port macro fails to apply to an interface, you can examine the point
of the failure in the
Interface Settings
macro after the error is corrected from the
Smartport is always available. By default, Auto Smartport is enabled by Auto
Voice VLAN, relies on both CDP and LLDP to detect attaching device's Smartport
type, and detects Smartport type IP phone, IP phone + Desktop, Switch, and
Wireless Access Point.
See
Voice VLAN
for a description of the voice factory defaults.
Auto Smartport is enabled by default and may be disabled. Telephony OUI cannot
function concurrently with Auto Smartport, and Auto Voice VLAN. Auto Smartport
must be disabled before enabling Telephony OUI.
This section describes some common tasks to setup Smartport and Auto
Smartport.
Workflow1: To globally enable Auto Smartport on the device, and to
configure a port with Auto Smartport, perform the following steps:
To enable the Auto Smartport feature on the device, open the
Set Administrative Auto Smartport to Enable or Enable by Voice VLAN.
Select whether the device is to process CDP and/or LLDP advertisements from
connected devices.
Select which type of devices are to be detected in the Auto Smartport Device
Detection field.
page and reset the port and reapply the
Interface Settings
11
page.
Properties
page.
202