Setting The Comparator Mode (Optional) - YOKOGAWA WT200 User Manual

9.5

Setting the Comparator Mode (optional)

Keys
Procedure
1.
SHIFT OUTPUT
Explanation
9-10
A
SAMPLE
V OVER
A OVER
MODE B
RMS
V MEAN
DC
C
SCALING AVG
• Operate the instrument by following the thick lines in the menu below.
• Press the ENTER key to confirm a selection or setting.
• To leave the current menu in the middle of the operation, press the key indicated in step 1.
The confirmed settings up to that point are kept.
Select the comparator function
(Display C)
SETUP
2.
Setting the Comparator Mode
The following two settings are available. For details related to the mode, see section
9.4. The initial value is SinGL.
• SinGL: the comparator mode will be set to single mode;
• duAL: the comparator mode will be set to dual mode.
Note
• When you change the comparator mode after having set the comparator limit (See section
9.6 and the following sections), the situation will change as follows. Also verify the
comparator limits again.
• When you change the mode to dual mode after setting the limits in the single mode, the limit
item (see section 9.6) for ch2 and ch4 are set to those for ch1 and ch3, respectively. When
the mode is set back to the single mode, the limit item of each channel returns to its original
value.
Do not change the comparator mode, measurement mode or harmonic analysis
ON/OFF, while the comparator function is turned ON (see section 9.8). Similar
to the Note above, changing the limit item might result in unexpected statuses of
the output relay.
m V VA
var
k A
M W
TIME
m V PF
k A
deg
M W
m V Hz
k A h
M W h
FILTER STORE RECALL HARMONICS
3.
(Display C)
ENTER
4.
CAUTION
AUTO AUTO
FUNCTION
V RANGE A RANGE HOLD
MODE MAX HOLD TRIG
FUNCTION
ENTER
CAL
INTEGRATOR
START STOP RESET
FUNCTION
HARMONICS MEMORY INTEG SET
REMOTE
LOCAL SETUP
INTERFACE OUTPUT SHIFT
Select the mode
5.
(Display C)
ENTER
6.
Displays
relevant
keys and
indicator
7.
ENTER
End
IM 253421-01E