Store Group - YOKOGAWA WT200 User Manual

STATus:FILTer<x>
Function Sets the transit filter/queries the current setting.
Syntax STATus:FILTer<x> {RISE|FALL|BOTH|NEVer}
STATus:FILTer<x>?
<x>=1 to 16
Example STATUS:FILTER2 RISE
STATUS:FILTER2?→:STATUS:FILTER2 RISE
Description See section 14.4, "Status Report" for details on
the condition filter.

14.3.14 STORe Group

The commands in the STORe group are used to make settings relating to and inquiries about storing data. This
allows you to make the same settings as when using the lower menus of [MEMORY]-"StorE" or [MEMORY]-"PnLSt".
;
:STORe : STAT e
INTer val
PANel
STORe?
Function Queries all settings related to storing data.
Syntax STORe?
Example STORE?→:STORE:STATE 0;INTERVAL 0,0,0
STORe:INTerval
Function Sets the interval for storage/queries the current
setting.
Syntax STORe:INTerval
{<NRf>,<NRf>,<NRf>|<String>}
STORe:INTerval?
{<NRf>,<NRf>,<NRf>}=0,0,0 to 99,59,59
{<String>}=HH:MM:SS
HH hour MM min SS sec
Example STORE:INTERVAL 0,0,0
STORE:INTERVAL "00:00:00"
STORE:INTERVAL?→:STORE:INTERVAL 0,0,0
Description • If the storage interval is set to 0,0,0, the
storage interval becomes 250 ms in case of
normal measurement.
• For the storage interval in case of harmonic
analysis, see page 8-2.
IM 253421-01E
STATus:QMESsage
Function
Syntax
Example
STATus:SPOLL?(Serial Poll)
Function
Syntax
Example
Description
<Space> OFF
ON
<NRf>
?
<Space> <NRf> ,
<character string>
?
<Space> <NRf>
?
STORe:PANel
Function
Syntax
Example
STORe[:STATe]
Function
Syntax
Example
Sets whether or not to apply the corresponding
message to the query "STATus:ERRor?" /
queries the current setting.
STATus:QMESsage {<Boolean>}
STATus:QMESsage?
STATUS:QMESSAGE OFF
STATUS:QMESSAGE?→:STATUS:QMESSAGE 0
Executes serial polling.
STATus:SPOLL?
STATUS:SPOLL?→STATUS:SPOLL 0
This command is dedicated to the RS-232-C
interface. An interface message is available for
the GP-IB interface.
<NRf> , <NRf>
Saves the setting parameters to a file.
STORe:PANel {<NRf>}
{<NRf>}=1 to 4:file number
STORE:PANEL 1
Sets store ON/OFF, queries the current setting.
STORe[:STATe] {<Boolean>}
STORe:STATe?
STORE:STATE ON
STORE:STATE?→:STORE:STATE 1
14.3 Commands
14
14-37