Outputting To An External Plotter Or Printer - YOKOGAWA WT200 User Manual

9.9

Outputting to an External Plotter or Printer

Keys
Procedure
• Setting the Output Mode
1.
LOCAL
SHIFT INTERFACE
*
The communication settings vary depending on the communication interface you purchased.
For details on the menus, see chapters 10 and 11.
• Setting the Output Items
1.
SETUP
SHIFT OUTPUT
9-18
A
SAMPLE
V OVER
A OVER
MODE B
RMS
V MEAN
DC
C
SCALING AVG FILTER
• Operate the instrument by following the thick lines in the menu below.
• Press the ENTER key to confirm a selection or setting.
• To leave the current menu in the middle of the operation, press the key indicated in step 1.
The confirmed settings up to that point are kept.
Set the output Mode
(Display C)
Communication setting
2.
3.
ENTER
End
3.
(Display C)
ENTER
2.
m V VA
FUNCTION
var
k A
M W
TIME
m V PF
FUNCTION
k A
deg
M W
m V Hz
FUNCTION
k A h
M W h
STORE RECALL HARMONICS
*
Set plotter or printer
5.
(Display C)
4.
(Display C)
5.
4.
ENTER
Displays
relevant
AUTO AUTO
V RANGE A RANGE HOLD keys and
MODE MAX HOLD TRIG
indicator
ENTER
CAL
INTEGRATOR
START STOP RESET
HARMONICS MEMORY INTEG SET
REMOTE
LOCAL SETUP
INTERFACE OUTPUT SHIFT
If the communication interface
that you purchased is an
RS-232-C, the menu proceeds
to the "Selecting handshaking
method" menu of page 11-3.
ENTER
Set the relevant parameters
such as the handshaking
End
method, format, and baud rate,
then press the ENTER key to
complete the settings. If the
communication interface is a
GP-IB, the procedure ends at
step 5.
Set the output items
(Display C)
6.
7.
ENTER
End
IM 253421-01E