Standard - YOKOGAWA WT200 User Manual

Command
Common Command Group
*CAL?
*CLS
*ESE
*ESR?
*IDN?
*OPC
*OPC?
*OPT?
*PSC
*RST
*SRE
*STB?
*TRG
*TST?
*WAI
IM 253421-01E
Description
Performs zero level compensation and queries the result.
Clears the standard event register, extended event register and error queue. 14-38
Sets/queries the value of the standard event enable register.
Sets/queries the value of the standard event register and clears it.
Queries the instrument model.
This command is not supported by this instrument.
This command is not supported by this instrument, and is always "1".
Queries installed options.
Sets/queries whether or not to clear some registers at power ON.
Initializes the present settings.
Sets/queries the value of the service request enable register.
Queries the value of the status byte register.
Executes the same operation as the TRIG(SHIFT+HOLD) key.
Executes a self-test and queries the results.
This command is not supported by this instrument.
Note
In the following pages, the character strings used in the descriptions of the <normal
measurement function> or the <harmonic analysis function> indicate the following data.
• <Normal measurement function>
V: voltage, A: current, W: active power, VA: apparent power, VAR: reactive power, PF: power
factor, DEGRee: phase angle, VHZ: voltage frequency, AHZ: current frequency, WH: watt
hour, WHP: positive watt hour, WHM: negative watt hour, AH: ampere hour, AHP: positive
ampere hour, AHM: negative ampere hour, MATH: MATH computation result, VPK: peak
voltage, APK: peak current.
• <Harmonic analysis function>
See page 14-30.
• Other
TIME: integration time, ORDer: harmonic order
14.3 Commands
Page
14-38
14-38
14-39
14-39
14-39
14-39
14-39
14-39
14-39
14-39
14-40
14-40
14-40
14-40
14
14-13