Communication-Related Error Messages - YOKOGAWA WT200 User Manual

14.7 Communication-related Error Messages

Errors in communications commands (100 to 199)
Code Message
102 Syntax error
103 Invalid separator
104 Data type error
105 GET not allowed
108 Parameter not allowed
109 Missing parameter
111 Header separator error
112 Program mnemonic too long
113 Undefined header
114 Header suffix out of range
120 Numeric data error
123 Exponent too large
124 Too many digits
128 Numeric data not allowed
131 Invalid suffix
134 Suffix too long
138 Suffix not allowed
141 Invalid character data
144 Character data too long
148 Character data not allowed
150 String data error
151 Invalid string data
158 String data not allowed
161 Invalid block data
168 Block data not allowed
171 Invalid expression
178 Expression data not allowed
181 Invalid outside macro definition Does not conform to the macro definition specified in IEEE488.2.
IM 253421-01E
Error messages related to communications are given below.
When servicing is required, contact your nearest YOKOGAWA representative, as given
on the back cover of this manual.
Only error messages relating to the communication mode 488.2 are given here. For
other error messages, see chapter 13 and section 15.4, "Error Codes and Corrective
Actions."
Action
Incorrect syntax
Insert a comma between data items to separate them.
See pages 14-7 and 14-8 and enter data using the correct
data format.
GET is not supported as a response to an interface message.
Check the number of parameters.
Enter the required number of parameters.
Insert a space between the header and the data to separate them. 14-4
Check the mnemonic (character string consisting of letters and
numbers).
Check the header.
Check the header.
Mantissa must be entered before the numeric value in <NRf> format.
Use a smaller exponent in <NR3> format.
Limit the number of digits to 255 or less.
Enter in a format other than <NRf> format.
Check the units for <Voltage> and <Current>.
Check the units for <Voltage> and <Current>.
No units are allowed other than <Voltage> and <Current>.
Enter one of the character strings in {...|...|...}.
Check the character strings in {...|...|...}.
Enter in a format other than one of those in {...|...|...}.
<Character string> must be enclosed by double quotation marks
or single quotation marks.
<Character string> is too long or contains characters which cannot Section 14.3
be used.
Enter in a data format other than <Character string>.
<Block data> is not allowed.
<Block data> is not allowed.
Equation is not allowed.
Equation is not allowed.
Reference Page
or Section
Section 14.2,
14.3
14-4
14-7, 14-8
—
14-7,
Section 14.3
14-7,
Section14.3
Section 14.3
Section 14.3
Section 14.3
14-7
14-8,
Section 14.3
14-8,
Section 14.3
14-8,
Section 14.3
14-8
14-8
14-8
Section 14.3
Section 14.3
14
Section 14.3
14-8
Section 14.3
—
—
Section 14.3
Section 14.3
—
14-51