YOKOGAWA WT200 User Manual page 138

Explanation
IM 253421-01E
Initializing Setting Parameters
Setting parameters will be initialized as soon as the ENTER key is being pressed in
the procedure described above. The initial settings are as follows.
Item
Display A
Display B
Display C
Number of displayed digits
Number of displayed digits
Filter
Measurement synchronization source
Measurement range
Measurement mode
Hold
MAX hold
PC/CT scaling constant
External sensor scaling constant
Averaging
MATH computing equation
Frequency
Integration
Harmonic analysis (option)
Storage/recalling
D/A output (option)
Comparator (option)
Data output
GP-IB
RS-232-C
Note
Be careful since measurement data will be lost when initializing. However, measurement data or
setting parameters stored in the internal memory will be kept.
12.2 Initializing Setting Parameters
Initial setting
Display function: V
Display function: A
Display function: W
Lo (4 digits)
4 digits
OFF
A
Auto range
RMS
OFF
OFF
P: 1.000, C: 1.000, F: 1.000
scaling ON/OFF: OFF
50.00A
Averaging type: exponential, attenuation constant: 8
Averaging ON/OFF: OFF
WT200: Voltage crest factor
VHz
Reset condition, integration mode: manual, integration
type: standard
Integration preset time: 0 hr, 0 min, 0 s
PLL source: V1, harmonic distortion factor computation
format: IEC,
Harmonic analysis function ON/OFF: OFF
Interval: 0hr 0min 0sec, storage/recalling ON/OFF: OFF
Output items: normal measurement items, rated
integration time: 1 hr, 0 min, 0 sec
Mode: single, limit item: (V1, A1, P1, PF1), limit value:
section 9.6, display function ON/OFF: OFF
Communication, item: normal measurement setting
Addressable mode: A, address: 1, status byte:15,
delimiter: 0
Normal mode, handshaking mode: 0, format: 0,
Baud rate: 9600, delimiter: 0, status byte: 15
12
12-3