YOKOGAWA WT200 User Manual page 124

Explanation
IM 253421-01E
Setting the Output Item in case of Normal Measurement
• Selecting the Default Setting
Predefined items will be output by the communication function. The following types
of default settings exist and they depend on the model. For details, see section
10.4.
• Normal default setting : dFLt-n
Consists of V (voltage), A (current), W (active power, the above menu shows P),
frequency and displayed data of display C.
• Integration default setting : dFLt-i
Consists of W (active power, the above menu shows P), Wh (watt hour), Ah
(ampere hour), frequency, and integration time.
• Selecting yourself
You can set any item to each of ch1 to ch14 output channels.
• Setting the channel
Sets which channel (ch1 to ch14) will output the item.
• Setting the output item (corresponds to column A in the operating procedure)
Any of the following items can be selected. The initial value is V.
V (voltage), A (current), P (active power), VAr (reactive power), VA (apparent
power), PF (power factor), VFrq (voltage frequency)
*1
frequency) , Ph (total watt hour Wh), Ah (total ampere hour), dEG (phase
angle),VP(peak value of voltage), AP(peak value of current),
MATH(computation), t1 (elapsed integration time), Ph+ (positive watt hour
Wh+), Ph– (negative watt hour Wh–), Ah+ (positive ampere hour
(negative ampere hour
*1 If either one of the display functions, V Hz or A Hz, is turned on, the frequency of the
corresponding function is output. If both functions are turned OFF, the frequency of the
function that was lighted last will be output.
*2 For details related to the positive and negative directions of the ampere hour, see page
6-3.
Setting the Output Item in case of Harmonic Analysis
The procedure to set the output item is the same as the procedure described in
section 9.9, "Outputting to an External Plotter or Printer."
For details, see section 9.9.
10.6 Setting the Output Items
*2
), – – – – (no output)
*1
, AFrq (current
*2
), Ah–
10-15
10