YOKOGAWA WT200 User Manual page 26

IM 253421-01E
Rack mount
To install the instrument in a rack, use one of the following optional rack mount kits.
• Rack mount kit (option)
Specifications
EIA Standard (for single mount)
JIS Standard (for single mount)
EIA Standard (for multiple mount)
JIS Standard (for multiple mount)
• Mounting procedure
1. Turn the handle to position 8 (see the figure on the previous page) and remove it
by pulling the handle outward along the rotational axis approximately 10 mm.
2. Remove the feet from the instrument.
3. Remove the seals covering the mounting holes from the front side of the
instrument.
4. Mount the rack mount brackets.
5. Mount the instrument in the rack.
For more detailed information regarding the rack mount procedure, refer to the
instruction manual accompanied with the rack mount kit.
Note
• When rack mounting the instrument, allow at least 20 mm of space around the vent holes to
prevent internal overheating.
• Make sure to have adequate support for the bottom of the instrument. However, do not block
the vent holes in the process.
3.2 Installing the Instrument
Kit
751533-E2
751533-J2
751534-E2
751534-J2
Turn the handle to
position 8 and remove
Turning axis
it by pulling it approx.
10 mm from the turning
axes on both sides.
3
3-3