YOKOGAWA WT200 User Manual page 190

14.3 Commands
MEASure[:NORMal]:ITEM:<normal
measurement function>:ELEMent<x>
Function Sets the communication output concerning
each element ON/OFF, queries the current
setting.
Syntax MEASure[:NORMal]:ITEM:<normal
measurement function>:ELEMent<x>
{<Boolean>}
MEASure[:NORMal]:ITEM:<normal
measurement function>:ELEMent<x>?
<x>=1
Example MEASURE:NORMAL:ITEM:V:ELEMENT1 ON
MEASURE:NORMAL:ITEM:V:ELEMENT?→
:MEASURE:NORMAL:ITEM:V:ELEMENT1 1
MEASure[:NORMal]:VALue?
Function Queries normal measured/computed data set
by commands other than
" MEASure[:NORMal]:ITEM
Syntax MEASure[:NORMal]:VALue?
Example MEASURE:NORMAL:VALUE?→10.04E+00,
10.02E+00, 10.03E+00,49.41E+00,...
Description • The renewal of normal measured/computed
data output here occures when bit0 (UPD) of
the condition register (see section 14.4)
changes from high to low. For details, see
14.2.6, "Synchronization with the Controller."
• For the output format of normal measured/
computed data, see page 14-29.
• When the harmonic analysis function is ON,
harmonic analysis data will be returned.
(Results are the same as for
MEASure:HARMonics:VALue?
14-28
".
)
IM 253421-01E