Structure Of This Manual - YOKOGAWA WT200 User Manual

Structure of this Manual

vi
This User's Manual consists of the following 16 chapters and an index.
Chapter 1 Functional Overview and Digital Display
Describes the input signal flow, functional overview, digital numbers/characters,
initial menus that are displayed when a key is pressed, and other information..
Chapter 2 Names and Uses of Parts and the Overrange and Error Displays
Gives the name of each part and each key, and describes how to use it. This
chapter also gives the displays in case of overrange/error during measurement.
Chapter 3 Before Starting Measurements
Describes points to watch during use and describes how to install the instrument,
wire the measuring circuits, connect the power cord and switch the power ON/OFF.
Chapter 4 Setting Measurement Conditions and Measurement Range
Explains settings such as measurement mode, filter ON/OFF, measurement range,
scaling in case of external PT/CT or external sensor (such as shunt or clamp),
averaging and measurement conditions.
Chapter 5 Displaying the Results of the Measurement and Computation
Explains the procedures for displaying the voltage, current, active power, apparent
power, reactive power, power factor, phase angle, frequency, peak value, value
derived from four arithmetical operations, and crest factor.
Chapter 6 Integration
Explains the procedures for integration of active power and current.
Chapter 7 Using the Harmonic Analysis Function (Optional)
Explains the procedures when using the harmonic analysis function.
Chapter 8 Storing/Recalling Measured Data and Setting Parameters from the Internal
Memory
Explains the procedures when storing or recalling measured data or setting
parameters from the internal memory.
Chapter 9 Using External Input/Output
Explains the procedures for remote control, D/A output (option), external plotter/
printer output and comparator (option).
Chapter 10 Using the GP-IB Interface (Optional)
Explains the procedures for controlling the instrument by personal computer and
for sending measurement/computed data to a personal computer using the GP-IB
interface.
Chapter 11 Using the RS-232-C Interface (Optional)
Explains the procedures for controlling the instrument by personal computer/
controller and for sending measurement/computed data to a personal computer/
controller using the RS-232-C interface.
Chapter 12 Initializing Setup Parameters and Performing Zero Level Compensation
Explains the procedures such as backing up setting parameter and initializing
settings.
Chapter 13 Communication Commands 1 (System of Commands before the IEEE 488.2-
1987 Standard)
Describes communication commands and sample programs that follow the rules
that existed before the establishment of the IEEE 488.2-1987 Standard.
Chapter 14 Communication Commands 2 (System of Commands Complying to the IEEE
488.2-1987 Standard)
Describes communication commands and sample programs that comply with the
IEEE 488.2-1987 Standard.
Chapter 15 Adjustment, Calibration and Trouble-Shooting
Explains the procedures for calibration, adjustment, the way to verify trouble, the
contents of error messages and the way to replace the fuse.
Chapter 16 Specifications
Describes the specifications of the instrument.
Index Index of contents.
IM 253421-01E