Configuring; Installing The Display Driver And Switcher Language Compiler - Barco TransForm A User Manual

3.5 Configuring

3.5.1 Installing the display driver and switcher language compiler

Initial steps for the installation
Please note: If using for the installation a USB mouse connected to a USB connector (no usage of
the PS/2 adapter), the mouse must be operable before logging in to the system. Therefore check,
whether the mouse pointer can be moved on the login screen. If it can not be moved, wait for
about 30 seconds and try again. If you log in before the mouse is operable the mouse support will
be temporarily disabled during the installation of the display drivers!
After switching on T
RANS
O S and O B
MNI CALERS MNI US
drivers. But first check the availability of the appropriate installation files. On the hard disk of the P
files of the latest release of the display driver suite are stored:
c:\BARCO\Windows Drivers (OVS-2686)\Windows Drivers X.X
Whenever the installation of a different release is required, e.g. if the latest release of the Wall Management
Software A requires an earlier release of the display driver suite, the respective folder Windows Driver
POLLO
Suite X.Y should be copied from CD TransForm A Suite CRS-3045-C to the folder
c:\BARCO\Windows Drivers (OVS-2686)
The Found New Hardware Wizard
The Found New Hardware Wizard comes up several times to install newly detected Barco components. The de-
tected hardware differs for a Processor or an OmniBus configuration. In an OmniBus configuration the driver for
the OmniBus comprises the control for the Barco expansion cards. In a Processor configuration these drivers have
to be installed for each device. The table below shows depending on the configuration how often the Found New
Hardware Wizard appears and how it names the detected devices:
Processor configuration
•
Each graphic channel detected as:
Video Controller (VGA compatible)
or
AGX-3000 AGX-3281
•
Each O S detected as:
MNI CALER
Multimedia Video Controller
or
AGX-3002 AGX-3313
The instructions on the next pages show exemplarily the installation for one O
Windows XP. Texts in the dialogs might differ according to the table above for different configurations.
With a Processor configuration take special care for the name used of the wizard.
Depending on this name the correct driver file has to be selected.
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
F A, log in as administrator. The operating system detects new graphic cards,
ORM
devices. Therefore the Found New Hardware Wizard comes up to install the suitable
or
or
OmniBus configuration
•
Each O B detected as:
MNI US
Video Controller (VGA compatible)
BARCO PCX-3003/3322/3360 (AGX-3000)
BARCO PCX-3003/3322/3360 (AGX-3281)
_______________________________________________________________
3. Getting started
ROCESSOR
or
or
B under Windows 2000 or
MNI US
the
3-41