Barco TransForm A User Manual page 27

The back
5 6
26b 27b
5 CPU board
6 link interface card
7-13 Barco expansion cards, e.g. graphic cards
14-20 Barco expansion cards, e.g. O
21-24 Barco expansion cards, e.g. input cards
25 air supply
26a, 26b power switch (a standard power module, b optional redundant power module)
27a, 27b mains connection (a standard power module, b optional redundant power module)
28 connection for equipotential bonding conductor
On the upper part of the back of the O
and the link interface board [6], followed by graphic cards, O
the configuration of T
RANS
On the right of the lower part is the standard mains connection [27a] and the power switch [26a]. On the left
side there might be another mains connection [27b] and the power switch [26b] for a second power module
for redundant operation, depending on the configuration of the T
connection there might be a connection for the equipotential bondig conductor [28].
To protect the O
kept free of obstructions!
To disconnect the O
the mains connection [27a] and [27b]. Therefore the back panel has to be easily accessible!
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
7-13
25
S
MNI CALER
B A18 there are different cards. On the left there is the CPU board [5]
MNI US
F A.
ORM
B A18 from overheating, the air supply openings in the case shall be
MNI US
B A18 from the power supply all power cords have to be pulled of
MNI US
14-20 21-24
28
S and input cards [7-24] depending on
MNI CALERS
F A. To the left of the standard mains
RANS ORM
_______________________________________________________________
3. Getting started
26a 27a
Figure 3-11
back of O B A18
MNI US
3-10