Cpu Board - Barco TransForm A User Manual

3.2.13 CPU board

The CPU board controls amongst other the remote power on/off mechanism between P
devices and the transmission of a genlock signal. It is part of each O
Connectors
On the CPU board there are two RJ-45 connectors for connecting the remote power on/off cables.
Do not remove the sheet metal plate. The connector behind is reserved for diagnostic
purposes.
Connecting order remote power on/off
All T F A devices of an OmniBus configuration should be connected in a daisy chain for remote power
RANS ORM
on/off mechanism. Therefore the remote power on/off connector [16] on the back of the P
connected with the remote power on/off in connector of the CPU board of the first O
power on/off out connector of this O
the next O B and so on. The remote power on/off out connector of the last O
MNI US
Do not mix up the connetors for remote power on/off with the mechanically identical
connectors of the network adapters!
Mixing the connectores will cause damage to the system!
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
B must be connected to the remote power on/off in connector of
MNI US
ROCESSOR
B .
MNI US
B remains unconnected.
MNI US
cabling for remote power on/off at O
_______________________________________________________________
3. Getting started
and the O B
MNI US
Figure 3-36
connectors of CPU board
must be
ROCESSOR
B . The remote
MNI US
Figure 3-37
B A18 devices
MNI US
3-27