Special Requirements When Installing Windows 2000/Xp - Barco TransForm A User Manual

6.1.7 Special requirements when installing Windows 2000/XP

If you want to reinstall and configure Windows 2000 or Windows XP on the T
cedure is required. The following description points out the details that must be considered to achieve a system
that optimally supports the T
Windows 2000/XP system installation.
Required parts
For the installation, the following CD-ROMs are necessary:
•
Microsoft Windows 2000 Professional
•
or Microsoft Windows XP Professional respectively
•
CRS-3045-C, T F
RANS ORM
Boot sequence
In the BIOS-settings, set the boot sequence to 1. Floppy, 2. ATAPI CD-ROM, 3. IDE Hard Drive. If the hard disk is
already partitioned you have to press a key when the text: Press any key to boot from CD ... ap-
pears. If the hard disk is not yet partitioned, the system boots automatically from CD.
Computer type
When the setup utility prompts you to press F6 for the installation of SCSI-/RAID-drivers, press F5. This will show
a list of the different computer types that are supported by Windows 2000/XP. In this list select Standard-PC.
Partition size
When you are asked for the partition size, create a partition with address c: . The size of this partition must not
be bigger than 8 GB. Format this partition in NTFS file system. If there is already a partition with these properties,
it is nevertheless recommended to reformat it.
Boot sequence
When rebooting change again the boot sequence in the BIOS-settings to 1. Floppy, 2. IDE Hard Drive, 3. ATAPI
CD-ROM. Windows 2000/XP boots now from the hard disk.
Licensing
Amongst other you will be prompted to insert the license number of your Windows 2000/XP. The license number
is labeled on the inside of the front flap of the P
lation is ready and you are prompted to remove the CD from the drive and to reboot the computer.
If the network identification Wizard comes up, then leave it with Cancel.
Graphic driver
Now the display drivers must be installed. Proceed as explained in section
switcher language compiler.
Update of network card driver
Insert the CD T F A Suite into the CD-ROM drive and setup the driver of the network adapter by means of a
RANS ORM
driver update in the device manager. Therefore open the device manager (Start -> Settings -> Control Panel ->
System -> Hardware Tab -> Device Manger ... ). Here you can select the suitable driver from the T
Suite. For this purpose there is an overview on the T
depending on the network card and the used operating system.
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
F A hard- and software, but it is not meant as a complete description of a
RANS ORM
A Suite for Windows 2000/XP
ROCESSOR
RANS
. After the system copied files to the hard disk the instal-
3.5.1 Installing the display driver and
F A Suite, about which driver should be selected
RANS ORM
_______________________________________________________________
6. Advanced configuration
F A hard disk, a special pro-
ORM
RANS
F A
ORM
6-24