Extender - Barco TransForm A User Manual

3.1.4 Extender

In a typical Processor configuration the PCI slots of the P
E extends the P
XTENDER ROCESSOR
sources can be connected in a Processor configuration. The E
a redundant hot plug power supply.
Small systems, which exceed the number of available slots in the P
Bus configuration or as a Processor configuration with an E
the slots of an E sufficient.
XTENDER
The front
The E looks like this or similar:
XTENDER
1 ventilation flap with air supply
2 lock of ventilation flap
3 On/Off-switch
4 green LED: power on
on
off
5 buzzer reset button: power module failed
6 red LED: power module failed
on
off
7 front flap
8 lock of front flap
On the front of the E
XTENDER
the top position is a buzzer reset button [5] to confirm the failure of a redundant power module. Between
these two buttons there are two LED's, the green LED power on [4] to the left is indicating if power is on. The
red LED power module failed [6] to the right indicates that a redundant power module is not operable.
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
by adding 13 PCI slots. Thus a bigger number of projection modules or more input
1 2
power is switched on
power is switched off
One power module has failed or power connection to a module is interrupted.
device is switched on, power modules OK, power output OK
or device is off, no power applies
behind the front flap [7] on the lowest position, there is the On/Off-switch [3]. On
are used for inserting all expansion cards. The
ROCESSOR
is available with a standard power supply or
XTENDER
can either be configured as an Omni-
ROCESSOR
, if the input requirements are moderate and
XTENDER
3
7
(only functional with redundant power supply)
(only functional with redundant power supply)
_______________________________________________________________
3. Getting started
4 5 6
8
Figure 3-13
Front view of the E
XTENDER
3-12