Displaying Video And Rgb-Signals; Display In A Window - Barco TransForm A User Manual

4.3 Displaying video and RGB-signals

4.3.1 Display in a window

•
On the P click the Start button on the taskbar and choose Run ... to display the Run dialog box.
ROCESSOR
•
Enter video as the program to be opened and if necessary the options, described in the table below. In-
stead of the system default names as well the names defined in the switcher definition file can be inserted,
see section 4.3.2 Naming of video channels and video
•
The software video opens the video window. With a right click on the video window a dialog box for con-
trolling the video display can be opened. The appearance and functionality of this dialog box depends on the
input card that provides the data source of the video that was started, please refer to the following sections
below for a detailed description of the operation of the various source types. S
sources must be configured before streaming video is shown. If video does not show up please refer also to
section 8.2 Other faults
The following table describes the available options:
/d:<video channel>
/v:<overlay>
/c:<config.file>
/e:<event>
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
for troubleshooting.
Specify video channel
(for description see below)
Specify the overlay plane. Values are:
use O
0
desktop plane
1
O
2
Default is 0.
Specify configuration file
(for description see below)
Open video window that will be closed and the video software will
be exited when <event> is sent. The same event may be associ-
sources.
S , if available
MNI CALER
S overlay plane
MNI CALER
________________________________________________________________
4. Operating
Figure 4-2
Starting the video software
V C and its
TREAMING IDEO ARDS
Figure 4-3
Video window and dialog box
4-7