Barco TransForm A User Manual page 35

Adapter cables
Depending on the configuration the card is delivered with different adapter cables:
•
Dual-DVI to 2×DVI-D adapter cable:
Digital output for display on projection modules with digital input.
•
Dual-DVI to 2×CRT adapter cable:
Analog output for display on projection modules with analog input.
Order
The first graphic card in respect to PCI slot numbering identifies itself as primary graphic adapter by lighting the
green LED of the respective graphic channel when T
channel, where the system emits diagnostic and status messages during system startup.
•
In an OmniBus configuration the graphic cards are plugged into the O
of the graphic cards, please refer to the sections
•
In a Processor configuration graphic cards are in most cases plugged in the P
cards are used the other graphic cards should be inserted in sequence to the primary graphic adapter into the
PCI slots and are numbered consequently following their numbering. Please refer also to section
Extender.
Each UGX G
C provides four ports for connecting projection cubes, monitors or projectors. The upper con-
RAPHIC ARD
nector contains port 0 and 1, the lower one contains port 2 and 3. Thus the sequence of the graphic channels is:
board
port 0
channel 1
As default the O V projection cubes and graphic channels are assigned in columns from top to bottom start-
VER IEW
ing with the left column (view from front of the screens). Please refer to section
for further details.
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
1
1
2
3
2 3 4
F A is switched on. The primary graphic adapter is the
RANS ORM
3.2.14 OmniBus.
2
0
1
2
5 6 7
_______________________________________________________________
3. Getting started
Dual-DVI to 2×DVI-D adapter cable
Dual-DVI to 2×CRT adapter cable
B devices. For the explicit order
MNI US
. If multiple graphic
ROCESSOR
3
0
1
3
8 9 10
3.5.3 Configuring the display wall
Figure 3-22
Figure 3-23
3.2.15
2
3
11 12
Figure 3-24
3-18