Barco TransForm A User Manual page 127

Orbiting
With the Orbiting entry in the registry orbiting of the display can be started and the orbiting time can be de-
fined.
Name
Orbiting
Typ DWORD
Value 0..FFFFFFFF hex
Default 0
Effective after one revolution or, starting from 0, after rebooting
Please, refer to section 3.5.2 Configuring the display driver
PanelResolutionOnly
With the PanelResolutionOnly entry is determined if the AGX G
native resolution of the display device or if it could also be operated in a lower resolution. This setting applies to
digital displays only.
Name
PanelResolutionOnly
Typ DWORD
Value 0 or 1
Default 0
Effective after rebooting
If value is set to 1 only the native resolution can be selected in the display properties dialog. This is also the case,
if the O S is used together with the graphic card. If value is 0, also lower resolution can be selected.
MNI CALER
This option has no effect on the display properties of the UGX G
of the selected value.
TransparentBlt
This option has no effect on the display properties of T
WriteCombining
With the WriteCombining entry in the registry write combining can be enabled on CPUs with Pentium Pro,
Pentium II, Pentium III, Pentium IV or Celeron processor.
Name
WriteCombining
Typ DWORD
Value 0 or 1
Default 1
Effective after rebooting
Write combining enables the CPU to transfer images to the graphical boards faster but may cause rendering er-
rors under rare conditions.
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
for more details (Orbiting).
C
RAPHIC ARD
C . It always uses the value 1 irrespective
RAPHIC ARD
F A.
RANS ORM
________________________________________________________________
6. Advanced configuration
Table 6-9
can only be operated with the
Table 6-10
Table 6-11
6-7