Network - Barco TransForm A User Manual

3.2.12 Network

LAN
For connecting the P
ROCESSOR
LAN adapter available:
•
Onboard LAN Adapter
•
Ethernet Card 100 Mbps
•
Ethernet Card 1000 Mbps
The onboard LAN adapter and the Ethernet Card 1000 Mbps have the ability to establish a 10 Mbps, 100 Mbps or
1000 Mbps connection. The Ethernet Card 100 Mbps has the ability to establish a 10 Mbps or 100 Mbps connec-
tion.
For a redundant connection to the LAN both cards are also available as server adapters, allowing to configure
them in teaming mode, sharing one single IP-address. You can see whether a network card is of server or desk-
top type on the label on the card. Please refer also to section
tion.
The onboard LAN adapter, the 10/100 Mbps and the 10/100/1000 Mbps network card offer each a Twisted Pair
connection:
Order
The network card is inserted in the PCI slot of the processor with the highest number. If several network cards
are used they are inserted consecutively.
Inserting a network card in an OmniBus or Extender is not supported!
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 13 – April 2006
to the LAN (local area network) there are two different network cards or an onboard
DATA
ACT/LNK
100 TX
Onboard LAN adapter (left), 100 Mbps Ethernet Card (middle) and 1000 Mbps Ethernet Card (right)
PCI 1 PCI 2
6.1.11 Redundant network adapter
DATA
ACT/LNK
10=OFF
100=GRN
1000=YLW
LAN LAN
Eth 2 Eth 1
PCI 3 PCI 4
_______________________________________________________________
3. Getting started
for more informa-
Figure 3-34
Connecting to Twisted Pair (RJ-45)
Figure 3-35
Network card in the P
ROCESSOR
3-26