Figure 82: Placing The Ethernet Line Card In Its Anti-Static Bag; Figure 83: Installing The Line Card Blank Cover - Allied Telesis x950 Series Installation Manual

Figure 82. Placing the Ethernet Line Card in its Anti-static Bag
8. Do one of the following:
For instructions on how to install another card in the slot, start with

step 2 in "Installing an Optional XEM2 Ethernet Line Card" on
page 82.
If you are not installing another line card in the slot now, continue

with the next step to install the blank cover.
9. Orient the blank cover as shown in Figure 83, with the notch on the
bottom left, and slid it into the slot.
Notch
Figure 83. Installing the Line Card Blank Cover
10. Tighten the two screws to secure it to the switch. Refer to Figure 84 on
page 146.
x950 Series Installation Guide for Stand-alone Switches
145