Figure 65: Moving To The Global Configuration Mode; Figure 66: Confirmation Prompt For The No Stack Enable Command; Figure 67: Returning To The Privileged Exec Mode - Allied Telesis x950 Series Installation Manual

5. Review the following items:
If the Operational Status is "Stacking Hardware Disabled," the

VCStack feature is already disabled on the switch. Go to
"Configuring Ports 25 to 37" on page 125.
If the Operational Status is "Standalone Unit," the VCStack feature

is enabled on the unit. You must disable it by performing the steps
in the rest of this procedure, to use the chassis as a stand-alone
switch. (The status says "standalone" because the device is
functioning as a stack of one switch.)
6. Enter the ENABLE and CONFIGURE TERMINAL commands to move
to the Global Configuration mode. Refer to Figure 65.
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z
awplus(config)#
Figure 65. Moving to the Global Configuration Mode
7. To. disable the VCStack feature, enter the NO STACK ENABLE
command in this format:
id
no stack
The ID parameter is the ID number of the switch, displayed on the ID
LED. Replace the parameter with whatever number is on the ID LED.
For example, if the Switch ID LED number is 1, you would enter the
command as follows:
awplus(config)# no stack 1 enable
This confirmation prompt in Figure 66 is displayed.
Warning; This will disable the stacking hardware on member-1.
Are you sure you want to continue? (y/n):
Figure 66. Confirmation Prompt for the NO STACK ENABLE Command
8. Type Y to disable VCStack on the switch.
9. Enter the EXIT command to return to the Privileged Exec mode. Refer
to Figure 67.
awplus(config)# exit
awplus#
Figure 67. Returning to the Privileged Exec Mode
x950 Series Installation Guide for Stand-alone Switches
enable
123