Activating Vcstack; Figure 52: Moving To The Privileged Exec Mode With The Enable Command; Figure 53: Moving To The Global Configuration Mode With The Configure Terminal Command; Figure 54: Activating Vcstack With The Stack Enable Command - Allied Telesis XS900MX Series Installation Manual

Activating VCStack

awplus(config)# stack enable
% The device needs to be restarted for this change to take effect.
awplus(config)#
If you determined in "Verifying the Status of VCStack" on page 85 that
VCStack is disabled, perform the following procedure to enable it:
1. Start a local management session. Refer to "Starting a Local
Management Session" on page 86.
2. Enter the ENABLE command to move from the User Exec mode to the
Privileged Exec mode, as shown in Figure 52.
awplus> enable
awplus#
Figure 52. Moving to the Privileged Exec Mode with the ENABLE
3. Enter the CONFIGURE TERMINAL command to move to the Global
Configuration mode, as shown in Figure 53.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
Figure 53. Moving to the Global Configuration Mode with the CONFIGURE
4. Enter the STACK ENABLE command to activate VCStack on the
switch, as shown in Figure 54 on page 89:
Figure 54. Activating VCStack with the STACK ENABLE Command
5. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 55.
awplus(config)# exit
awplus#
Figure 55. Returning to the Privileged Exec Mode with the EXIT Command
XS900MX Series Installation Guide for VCStack
Command
TERMINAL Command
89