Saving Your Changes And Rebooting The Switch; Figure 48: Returning To The Privileged Exec Mode; Figure 49: Saving The Changes With The Write Command - Allied Telesis AlliedWare Plus x530DP Series Installation Manual

Saving Your Changes and Rebooting the Switch

After disabling the VCStack feature, save your configuration changes and
reboot the switch. Changes to the status of the VCStack feature do not
take affect until after you reboot the unit.
To save your configuration changes and reboot the switch, perform the
following procedure:
1. To return to the Privileged Exec mode, from the Global Configuration
mode, type the command EXIT.
awplus(config)# exit
awplus#
Figure 24. Returning to the Privileged Exec Mode
2. To save your change in the configuration file, type the command
WRITE.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 25. Saving the Changes with the WRITE Command
This is the initial management session, the switch automatically
creates the Default.cfg configuration file and stores the change in the
file.
3. To reboot the switch, type the command REBOOT.
4. To confirm, type "Y" for yes.
5. Wait two minutes for the switch to initialize the management software
and then examine the Switch ID LED again. The switch is ready for
normal network operation as a standalone unit if its ID number is "0." If
the number is not "0," repeat the procedures in this chapter, being sure
to save your configuration changes with the WRITE command.
6. Go to Chapter 10, "Cabling the Networking Ports" on page 115.
x530DP Series Installation Guide for Standalone Switches
107