1
Safety and requirements for product use
1
Safety and requirements for product use
1.1
Technical data
Note
The technical data are contained in a separate data sheet, depending on the order.
Damage to the product from incorrect use and non-compliance with the technical data.
The separate data sheet as well as the CAD model are components of the product docu
mentation and must be downloaded as follows.
Determine order ID of the handling system (è product labelling on the Y-module).
Download data sheet and CAD model from the Festo Support Portal by specifying
the order ID (è www.festo.com/sp).
Print out data sheet and keep it together with this description.
Dimensions and other required measurements should be derived from the CAD model.
Illustrations in this description are shown as examples. The product can deviate, de
pending on the order.
1.1.1
Ordered strokes [mm]
For single-axis system and linear gantry:
Determine stroke in Y-direction (Hy) (è product labelling on the Y-module):
– Hy = stroke in Y-direction e.g. B.: EHMY-LP-EGC-120-TB-KF-1000-...
For planar surface gantry and three-dimensional gantry:
Determine width in Y-direction (By) and stroke in X-direction (Hx) (è product labelling on the
X-module):
– By = width in Y-direction
– Hx = stroke in X-direction e.g. B.: EHMX-EGC-120-TB-KF-1200-642-...
Festo – GDCP-YXC-EN – 1506a – English
e.g. B.: EHMX-EGC-120-TB-KF-1200-642-...
7