Torque 1) - Festo YXC Series Description

5 Installation of the planar surface gantries and the three-dimensional gantries
8. Align X-axes exactly with each other.
Partially mounted system
è chapter 5.3 page 59
Completely mounted system
è chapter 5.4 page 77.
9. Screw adjusting bolts in or out
(maximum height compensator è table).
10.Tighten screws. Apply counter pressure to the
adjusting bolt.
Check:
– The adjusting bolt has not twisted.
– The alignment has been maintained.
11.Make sure there is sufficient screw-in depth m
of the screw (è table).
Screw size and tightening
1)
torque
M
A
m
h
Max. height compensator [mm]
1) Screw, tightening torque and screw-in depth are designed for mounting on steel.
58
EHMX-EGC-
50
M5x30
[Nm] 5.9
 12
[mm]
[mm] 7 ± 2
4
80 120
M8x40
34
 15
8 ± 3
6
Festo – GDCP-YXC-EN – 1506a – English
185