Festo YXC Series Description page 37

4 Installation of the single-axis systems and the linear gantries
10.Fasten adjusting piece to the mounting sur­
face with suitable screws.
11.Align Y-module horizontally as follows:
– Screw the screw on the adjusting piece
in or out.
12.Screw nut in tightly. Apply counter pressure
to screw. (Tightening torque 2.5 ... 10 Nm)
Check:
– The screw has not twisted.
– The alignment has been maintained.
13.Evenly tighten screws.
Screw size and tightening
torque
[Nm]
Festo – GDCP-YXC-EN – 1506a – English
EHMY-LP-EGC-...-KF
50 80 120
M3x8 M5x16 M8x20
1.7 5.9 20
EHMY-LP-EGC-...-HD
185 125 160
M5x16
5.9
220
M8x20
20
37