5
Installation of the planar surface gantries and the three-dimensional gantries
5.2
Mounting components
5.2.1
Mounting kit without adjustment possibility
Structure
1
Lower part
2
Screw, lower part
3
Upper part
4
Screw, upper part
1) Screw and tightening torque are designed for mounting on steel.
Requirements
– Number n of mounting components is known (è 5.1.2 Number n of mounting components).
– Mounting surface is prepared (è 5.1.3 Preparation of the mounting surface).
Mounting
Warning
Incorrect attachment. Entire product moves uncontrollably.
Injury due to impact or pinching. Damage to the product.
Use screws 2 with strength class of at least 8.8.
Select screws 2 suitable for the installation situation.
Mount product free of distortion.
Use only the mounting kits supplied.
Secure threaded connections.
Make sure the mounting surface is sufficiently strong to absorb the maximum
forces.
Place X-axes
Partially mounted system è chapter 5.3 page 59
Completely mounted system è chapter 5.4 page 77.
52
(1x)
1)
(2x)
(4x)
(4x)
3
2
1
The mounting kits are pre-mounted to the
X-axes.
Check number n and support spacing X2.
Festo – GDCP-YXC-EN – 1506a – English
4