AC90 TENSION CONTROL FREQUENCY INVERTER MANUAL
BASIC OPERATION AND TRIAL RUN
Mouth keyboard with box
Mouth keyboard without box
70
61
Chart 3-14:AC90 series inverter mouth for 2 line LED keyboard dimension
Dismantle and install tail-hood
Installation: First the tail-hood upwardly inclines around 15
degrees and inserts the top fixed flat into the fixed hole in
the front cover. Then slightly press the tail-hood downward.
While your hear "Ka", it means that the tail-hood is into the
place.
Chart 3-15:AC90 series inverter tail-hood installation
Dismantlement: At the tail of the frequency inverter, there
is a special dismantlement hole design. Put your finger into
the hole, upwardly pull the cover with a little force until the
buckle between the tail-hood and the crust tear off, and then
remove the tail-hood down.
Chart 3-16:AC90 series inverter tail-hood ismantlement
19