Table of Contents
Advertisement
AC90 TENSION CONTROL FREQUENCY INVERTER MANUAL
Tension
Set
tension
actual tension
20% Set
tension
initial diameter
Tension tape coefficient=100%
Tape compensation modify=0mm
Tape compensation
F9.06
modify
It is tension tape control assistant parameter. Increase this value after settle down the tension tape can make output
tension decrease slowly while roll diameter increase. Otherwise, decrease it can make output tension increase quickly
while roll diameter increase.
Tension
Set
tension
actual tension
initial diameter
Tension tape coefficient=50%
Tape compensation modify=0mm
F9.07- F9.08
Reserved
F9.09
Machine drive ratio
Machine drive ratio: It means the deceleration ratio of the drive motor output speed and winding reel speed or
unwinding reel speed.
It is very important in the tension control process. It must rightly set the machine drive ratio.
F9.10
Curl mode
Select Curl mode to supply two shortcut for winding and unwinding
0: Winding
Under winding tension control, tension direction is fixed to be winding tension direction, consistent to the
run direction under speed control.
1: Unwinding
Under unwinding control, tension direction is opposite to syterm control run direct. While no load, run
direction also opposite to the normal unwinding direction.
Tension
Set
tension
60%Set
tension
initial diameter
5time initial
actual
diameter
diameter
Tension tape coefficient=50%
Tape compensation modify=0mm
Setting range:0-10000mm
Tension
Set
tension
initial diameter
actual
diameter
Tension tape coefficient=50%
Tape compensation modify=200mm
Tape compensation modify
Setting range:0.01-300.00
Machine drive ratio = motor output speed / winding reel speed
Setting range:0-1
actual tension
5time initial
diameter
Tension tape show
actual tension
actual
diameter
119
Function Parameter specifications
Tension
Set
tension
actual tension
initial diameter
actual
diameter
Tension tape coefficient=0%
Tape compensation modify=0mm
Factory set: 0
Tension
Set
tension
actual tension
initial diameter
Tension tape coefficient=50%
Tape compensation modify=500mm
Factory set:1.00
Factory set:0
actual
diameter
actual
diameter
Advertisement
Table of Contents
