Veichi AC90 Manual page 129

AC90 TENSION CONTROL FREQUENCY INVERTER MANUAL
6: RS485 gives and modifies the material thickness.
F9.40 Material thickness 1
F9.41 Material thickness 2
While Material thickness set resource ［F9.39］ is "0",It can select "material thickness selection terminal" to define any
terminals. Details see ［F2.00-F2.07］ Set thickness by terminal switch can bring two group traction linear speed.
Relationship table as below:
Material thickness selection terminal
F9.42
F9.43
Time calculate:
F9.44 Full roll diameter 1
F9.45 Full roll diameter 2
While roll diameter calculation selection [F9.11] is 3, [F9.44-F9.48] are valid. It can set full roll diameter by terminal
switch.It can select "full roll diameter selection terminal" to define any terminals. Details see [F2.00-F2.07] Set full roll
diameter by terminal switch can bring two group full roll diameter. Relationship table as below:
Full roll diameter selection
F9.46 Empty to full roll time 1
F9.47 Empty to full roll time 2
It sets the time from empty roll to full roll. It can set empty to full roll time by terminal switch.It can select "empty to full
roll time selection terminal" to define any terminals. Details see [F2.00-F2.07] . Set empty to full roll time by terminal
switch can bring two groups empty to full roll time. Relationship table as below:
Empty to full roll time selection
F9.48 Current time
It is used to monitor winding run time in real time.
F9.49-F9.51
Setting range:0.01-100.00mm
Setting range:0.01-100.00mm
OFF
ON
Setting range:1-10000mm
Setting range:1-10000mm
OFF
ON
Setting range:0-65000s
Setting range:0-65000s
OFF
ON
Refer range:0-65000s
124
Function Parameter specifications
Material thickness
Material thickness 1
Material thickness 2
Reserved
Reserved
Full roll diameter
Full roll diameter 1
Full roll diameter 2
Empty to full roll time
Empty to full roll time 1
Empty to full roll time 2
Reserved
Factory set:0.01mm
Factory set:0.01mm
Factory set:500
Factory set:500
Factory set:3600
Factory set:7200
Factory set: *