Veichi AC90 Manual page 128

AC90 TENSION CONTROL FREQUENCY INVERTER MANUAL
Linear speed selection terminal
F9.30 Current linear speed
Monitor the current linear speed in real time.
F9.31 Traction roller diameter
Traction roller pulse per
F9.32
cycle
While ［F9.25］ Linear input resource is 6, inverter gains traction linear speed by detection traction roller pulse signal. It
needs traction roller pulse per cycle and traction roller diameter.
Traction roller pulse per cycle: Nos of pulse per cycle of the traction roll in winding process.
F9.33 -F9.35
Thickness calculate:
F9.36 Pulse per cycle
F9.37 Cycles per layer
While roll diameter calculation selection [F9.11] is 2, [F9.36-F9.41] are valid. PUL port is pulse input port default.
Inverter calculates the thickness by pulse from PUL port.
Pulse per cycle: Pulse is coming from one cycle in winding process.
Cycles per layer: Cycles which are needed for one layer of winding roll finish.
F9.38 Max thickness
Max thickness of material permit. While thickness is analog input, max analog input corresponds to the max thickness.
And they are linear relationship.
Material thickness set
F9.39
resource
It is used to select material thickness gain mode:
0: F9.40/F9.41 terminal select
1: Keyboard potentiometer gives and modifies the material thickness.
2: VS1 gives and modifies the material thickness.
3: VS2 gives and modifies the material thickness.
4: AS gives and modifies the material thickness.
5: PUL gives and modifies the material thickness.
OFF
ON
Setting range:0.0-6500.0m/Min
Setting range:0.0-1000.0mm
Setting range:1-60000
Setting range:1-60000
Setting range:1-10000
Setting range:0.01-100.00mm
Setting range:0-5
Select material thickness by terminals switch. details see [F9.40-F9.41] .
123
Function Parameter specifications
linear speed setting
Linear speed setting 1
Linear speed setting 2
Reserved
Factory set:
*
Factory set:100.0mm
Factory set:1
Factory set:1
Factory set:1
Factory set:1.00
Factory set: 0