Pause - ETC ColorSource Console User Manual

The Sequence Run/Step button is located in the
play below each sequence and will only control that particular sequence. The button is a toggle that either lets
you stop a sequence so you can manually go through the steps by pressing the
the steps automatically.
Operation
Select a bump for the playback you want to stop or start.
Running sequences are indicated by a yellow bump button.
Stopped sequences are indicated by a blue bump button.
Stopped sequences may be advanced by pressing the blue bump button.
Note:
Tap Tempo
Places the
Hold Tap and press the bump of a playback carrying a sequence (shown in yellow on the bump) in the rhythm
you want for the sequence rate.
Press several times until the rate is correct.
Tap can be assigned to a bottom button by going to the
GO
Advances the
The next position may be the following entry in the cue list, or it may be somewhere else if you are jumping to
another cue
The live cue is displayed surrounded by a yellow box with the next cue displayed in a red box beneath it and
the previous cue above it.
Press GO twice or more to rapidly advance to further cues.

Pause

Stops the cue list
Press GO to resume crossfading and running times.
Recording Your Looks For Playback
Stopped sequences may be used as additional cue lists if required.
bump buttons for playbacks
cue list to the next position using the
or flag.
at its current position. Any fades that are underway will be stopped.
Playback Toy display. A Sequence Run/Step button will dis-
carrying sequences into 'Tap' mode.
Console tab
default cue times.
bump button, or it runs through
under Setup.
41