ETC ColorSource Console User Manual page 38

be made as complete new states for each cue by leaving the cues master down and making a new
state for each recording.
Store And Next
The current lighting levels will be stored in the selected
cues can be recorded. Use
Note:
put. To remove the newly made cue take the
made as changes (deltas) by leaving it up and making the necessary adjustments for each cue, or to
be made as complete new states for each cue by leaving the cues master down and making a new
state for each recording.
Cue List
A list of timed cues.
The live and next cues are indicated on the main cue list and also in the
in the upper right corner. The live cue displays in yellow and the next cue is in red.
Cues are played back with the Cue Transport (
crossfader
The Cue Transport buttons are Back, Pause, and GO. These buttons may be assigned to the hard buttons
below the screen, and are also always available by pressing on the cue list indicator in the upper right corner.
Note:
Cue List Indicator
The live and next cues are indicated on the main
corner of the touchscreen.
The live cue displays in yellow and the next cue is in red. If a crossfade is underway, both will display in red.
Progress bars indicate the in and out fade position. When a follow time is running, a green status bar will dis-
play.
Note:
The remaining progress will be shown in the cue list indicator.
34
Store to close the recording mode and resume normal operation.
Once a cue is recorded, it is placed on the live side of the cue
up and down, or through the
For the cues to be seen on stage, the cues fader must be up.
When a crossfade is paused mid-way, it may be manually resumed by using the crossfader.
cue and recording will be remain open so additional
cues master down. The cues master allows cues to be
cues fader
cue list and also in the cue list indicator in the upper right
crossfader and sent to the out-
cue list indicator (
) buttons, by moving the
Recording Your Looks For Playback
)