Colorsource - ETC ColorSource Console User Manual

Stopped sequences are indicated by a blue bump button.
Stopped sequences may be advanced by pressing the blue bump button.
To Update a Sequence Step
1. Stop the sequence by using the Seq Run/Step button, which is accessed by pressing the playback
mode button
2. Use the bump button to advance to the step you wish to edit.
3. Then you may alter the lighting and effects as required.
4. When the edit is complete, select Update Seq Step to save the changes. Update Seq Step will display
only when a step needs updating.
5. Pick the bump of the sequence to be updated to complete the update.
Sequence Rate
Sequences
ing.
Press Seq Rate and then select a
The wheel will change to indicate rate control and the percentage of the rate will be shown on the wheel.
Sequence rate may also be viewed and altered on the playbacks page.
Sequence Run / Step Control
Sequences
ing.
40
Note:
Stopped sequences may be used as additional cue lists if required.
in the Playback Toy
Note:
There may be several stopped sequences at any given time.
play back on the playback
bump
play back on the playback
display.
faders. A sequence may contain up to 99 steps with fade and step tim-
for the playback you want to rate control.
faders. A sequence may contain up to 99 steps with fade and step tim-
Recording Your Looks For Playback