Fader Mode; Bumps; Crossfader; Master Faders - ETC ColorSource Console User Manual

Fader Mode

The faders to the left of the display may be set to operate individual
Two pages of channels are provided and ten pages of playbacks.
Note:

Bumps

The buttons below the faders are bump buttons.
Their operation changes based on the
When the faders are in
When the faders are in

Crossfader

The Crossfader can be assigned to one of the four faders above the touchscreen. It is assigned in the
tab in Settings.
The Crossfader provides manual control over the fades between cues. You can see the progress of the cross-
fade and which cues are affected in the cue viewer.

Master Faders

Master faders can be used to control the output of certain functions. Master faders are assigned to the top four
faders. They are assigned in the
Note:
tions.
Master faders default to these functions:
Bumps: controls the output when a
Playbacks: controls the output of the
Cues: controls the output of the
Crossfader:
In Simple Mode
Memory 1- 4: The playback memories are the four faders above the touchscreen. You may
output and store it on one of the four masters to be re-used later.
ColorSource Overview
See channels for information on faders and captured channels.
fader
channel mode, the bumps can be used to select or deselect channels.
playback mode, their behavior is set based on the selected
Console tab
When the Playbacks or Cues faders are fully down no output will be produced by those sec-
cue
Crossfades the cue list from the Live to the Next step.
channels
mode.
in Settings.
bump button is pressed.
playbacks and sequences.
list.
or playbacks.
button mode.
Console
record the
7