Table of Contents
Advertisement
Required tools
Make sure the following tools are available during the installation.
•
12 in. screwdrivers: Phillips #2 (magnetic) and flat
•
2.5mm, 3mm, and 5mm hex drivers (provided with the projector)
•
Adjustable wrench
•
Step stool
•
Powder-free N-DEX gloves
•
Clean dry air (CDA)
Preparing the installation site
Ensure the installation area is ready for the components.
1. Clear the installation area.
2. Post laser hazard warning signs at all entry doors.
3. Place each component near its installation location.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
•
Do not stack more than three projectors in landscape orientation.
Position the projector so it is centered and parallel with the screen. If space is limited, aim the
projector slightly off-center and use lens offset to center the image on the screen.
Christie M RGB Series Installation and Setup Guide
020-103483-04 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
24
Advertisement
Table of Contents
