Table of Contents
Advertisement
•
Clean dry air (CDA)
Preparing the installation site
Make sure the installation area is ready for the components.
1. Clear the installation area.
2. Place each component near its installation location.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
•
Do not stack more than two projectors in landscape orientation.
1. If stacking the projector, make sure the bottom projector is level by adjusting the roll of the
lens axis to ensure the stability of the stack.
2. Position the projector so it is centered and parallel with the screen.
If space is limited, aim the projector slightly off-center and use lens offset to center the image
on the screen.
Leveling the projector
Use the projector feet to level the projector.
1. To adjust the vertical position of the projector, extend or retract the adjustable feet on the
bottom of the projector using the adjustable knobs on the feet.
Christie recommends adjusting the feet from the side or rear of the projector and not the front
to avoid exposure to the output light.
Christie Griffyn Series Installation and Setup Guide
020-103314-12 Rev. 1 (07-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
31
Advertisement
Table of Contents
