Table of Contents
Advertisement
ID
Component
A
Coolant hose
B
Reservoir fill cap
C
Coolant inlet port
D
Coolant outlet port
E
Exhaust vent
F
Communication signal terminal
G
Power supply terminal
H
Chiller coolant filter
I
Coolant drain port
Preparing the installation site
Make sure the installation area is ready for the components.
1. Clear the installation area.
2. Place each component near its installation location.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
Lift equipment must be used to position the product.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
This product must be installed in a landscape orientation, with all four feet supported on a level
surface. Do not install or operate the projector in an inverted position. If your site has any installation
requirements other than a typical theater projection booth, contact Christie for assistance.
CP4445-RGB and CP4455-RGB Installation and Setup Guide
020-103746-01 Rev. 1 (11-2022)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
25
Advertisement
Table of Contents
