Lifting And Positioning The Projector; Leveling The Projector - Christie Roadie D4K40-RGB Installation And Setup Manual

Hide thumbs Also See for Roadie D4K40-RGB:

Table of Contents

Only use the holes located on the handles for installing the feet in portrait mode.

6. To assist with stability and prevent sway, Christie recommends installing two 2-inch ProBurger

clamps on each handle. Orient the clamps on either side of the projector's center of gravity.

Lifting and positioning the projector

Safely lift and position the projector in the location where it will be used.

Warning! If not avoided, the following could result in death or serious injury.

•

A minimum of four people or appropriately rated lift equipment is required to safely lift, install,

or move the product.

•

Do not install or operate the projector in any position that does not meet the stated product

specifications for alignment and orientation.

1. Position each person at the corners of the projector.

2. Lift up the projector and move it to the location where it will be used.

3. Position the projector so it is centered and parallel with the theater screen.

If space is limited, aim the projector slightly off-center and use lens offset to center the image

on the screen.

Use the projector feet to level the projector.

1. To adjust the vertical position of the projector, extend or retract the adjustable feet on the

bottom of the projector using the adjustable knobs on the feet.

Christie recommends adjusting the feet from the side or rear of the projector and not the front

to avoid exposure to the output light.

D4K40-RGB Installation and Setup Guide

020-102961-06 Rev. 1 (09-2022)

If printed, please recycle this document after use.

Installation and setup

Table of Contents