Installing The Server Chassis In A Rack - Cisco UCS C4200 Installation And Service Manual

Server chassis
Table of Contents

Advertisement

Installing the Server Chassis in a Rack

Installing the Server Chassis in a Rack
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
unit in the rack.
Statement 1006
Step 1
Attach the inner rails to the sides of the server:
a) Align an inner rail with one side of the server so that the four keyed slots in the rail align with the four pegs on the
side of the server.
b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs.
c) Install the second inner rail to the opposite side of the server.
Figure 4: Attaching the Inner Rail to the Side of the Server
1
Front of server
Step 2
Install the outer slide rails into the rack:
a) Align one slide-rail assembly front end with the front rack-post holes that you want to use.
The slide rail front-end wraps around the outside of the rack post and the mounting pegs enter the rack-post holes
from the outside-front. See
b) Push the mounting pegs into the rack-post holes from the outside-front.
c) Adjust the slide-rail length, and then push the rear mounting pegs into the corresponding rear rack-post holes from
the inside of the rack post. You must push aside the spring-loaded securing clip that wraps around the rear rack post.
Note
The slide rail must be level front-to-rear.
Cisco UCS C4200 Server Chassis Installation and Service Guide
12
Figure 5: Attaching the Slide Rails to the Rack (View from Inside Rack), on page
2
Inner rail
Installation and Initial Setup
13.

Advertisement

Table of Contents
loading

Table of Contents