Installing The Power Supply; Inserting The Power Supply In The Chassis - Cisco AS5350 Installation Manual

Installing the Power Supply

Installing the Power Supply

To install the power supply, follow this procedure:
Step 1 Place the power supply as shown in Figure B-11, then slide it toward the rear panel. You will be able to
feel the chassis hooks engage with the slots on the bottom of the power supply. The same procedure
applies to both the AC and DC power supplies.
Figure B-11 Inserting the Power Supply in the Chassis
Step 2 Connect the two power connectors to the system board and backplane. (See Figure B-8.) Connect the
system board connector first, followed by the backplane connector. (See Figure B-12.)
Note
Cisco AS5350 Universal Gateway Chassis Installation Guide
-10
Power
supply
3
Front panel
The system board connector is located on the system board, below and left of the backplane
connector.
Chassis bottom
Appendix
78-10754-03 0A