Removing A Power Module Slot Cover; Prerequisites - Cisco SRS Series Installation Manual

Removing a Power Module Slot Cover

Figure 49: Installing PM Slot Cover
What to do next
After the PM slot covers are installed in the chassis, install the upper grille on the front (PLIM) side of the
chassis.
Removing a Power Module Slot Cover
This section describes how to remove a PM slot cover from a PM slot in a modular configuration AC or DC
power shelf.

Prerequisites

Before performing this task, you must first remove the upper grille on the front (PLIM) side of the chassis, if
installed.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
90
Installing and Removing Power Components