Setting up the machine
2.9 MDA
2.9.3
Executing an MDA program
Proceed as follows
When executing the G-code commands, you can control the sequence as follows:
● Executing the program block-by-block
● Testing the program
● Setting the test-run feedrate
See also
Program control (Page 98)
72
1.
Select the "Machine" operating area.
2.
Press the <MDA> key.
The MDA editor opens.
3.
Input the desired G-code commands using the operator's keyboard.
4.
Press the <CYCLE START> key.
The control executes the input blocks.
Settings under program control
Settings under program control
Operating Manual, 03/2010, 6FC5398-6AP10-4BA0
Universal