Proxim Tsunami MP-8100 Series Reference Manual page 18

Static Route Table Configuration
System Name(config-net)# static-route-table
System Name(config-net-static-staticroute)# rowadd 0 entry-status create
System Name(config-net-static-staticroute)# rowadd 0 metric 2
System Name(config-net-static-staticroute)# rowadd 0 destination-address 10.0.0.1
System Name(config-net-static-staticroute)# rowadd 0 route-mask 255.255.255.0
System Name(config-net-static-staticroute)# rowadd 0 route-nexthop 169.254.131.89
System Name(config-net-static-staticroute)# rowadd 0 entry-status create
System Name(config-net-static-staticroute)# exit
System Name(config-net-static)# exit
System Name(config-net)#exit
System Name(config)#exit
To display Static Routes configured in the table, use the following command:
System Name# show network static-route
// NETWORK STATIC ROUTE TABLE CONFIGURATION //
INDEX 1
Destination Address
Route Mask
Route Next Hop
Metric
Entry Status
NAT
Enter the following commands to configure and enable NAT.
1. NAT is configurable only when the Device Radio Mode is SU and Network Mode is Routing.
2. Changes to NAT parameters, including the NAT Static Port Mapping Table, require a commit and reboot to take effect.
3. When NAT is enabled, the DHCP Relay Agent and RIP must be disabled.
To enable NAT functionality and to enable Static NAT Port Bind Table status, use the following commands:
System Name(config-net)# nat
System Name(config-net-nat)# nat-status enable
System Name(config-net-nat)# port-bind-status enable
Tsunami MP-8100 Reference Manual
: 10.0.0.1
: 255.255.255.0
: 169.254.131.89
: 2
: enable
Command Line Interface
18