Reboot; Show Command - Proxim Tsunami MP-8100 Series Reference Manual

1.5.2 Reboot

For some commands, such as Frequency Domain, Radio Mode and others, it's necessary to commit and reboot the system to
reflect the changes. This can be done by using the reboot command under configure level. For this, follow the procedures
shown below before exiting the configure mode.
System Name> enable
System Name# configure
System Name(config)#reboot
Possible completions:
<yes(1)/no(2)>
System Name(config)# reboot 1

1.5.3 Show Command

System Name> show ?
Possible completions:
hostname
ip
licensed-feature
system-information
tech-support
When you enter show command along with ? at the CLI command prompt, it lists the following feature that you can
configure or view.
When you execute show command in user mode, you will get few commands only. But in privileged mode, all available
commands under show are displayed and can be executed.
You can execute show command only when you are in user mode or privileged mode, but not in Global configuration mode.
System Name# show ?
Tsunami MP-8100 Reference Manual
?
Reboot the device. Set 1 to reboot
Display the Host Name Information
Display the Ip Information
Display the license feature Information
Display the System Information
Display Technical Support Information
Command Line Interface
13