Proxim Tsunami MP-8100 Series Reference Manual page 22

•
Routing Mode.
System Name(config)# system-configure
System Name(config-sysconfig)# ?
Possible completions:
country-code
Exits Back to Global Configure Mode
frequency-domain
network-mode
System Name(config-sysconfig)# country-code AT
Country Code is configurable only in AP mode.
Error in configuration parameters, Please verify Your Configuration
System Name(config-sysconfig)# network-mode bridge
Changes in Network Mode requires Commit and Reboot.
System Name(config-sysconfig)# frequency-domain ?
Possible completions:
<unitedstatesall(1),unitedstatesadhoc(2),unitedstates2p4(3),worldall(4),world4p9ghz(5),wor
ld2p4ghz(6),world2p3ghz(7),world2p5ghz(8),canada5ghz(9),europe5p8ghz(10),europe5p4ghz(11),
europe2p4ghz(12),russia5ghz(13),taiwan5ghz(14),unitedstates5ghz(15), canada5p8ghz(16)>
configure the Frequency Domain
System Name(config-sysconfig)# frequency-domain 14
Changes In Frequency Domain Requires Reboot.
System Name(config-sysconfig)#exit
System Name(config)#exit
System Name#exit
System Name# show system-type
// SYSTEM COUNTRY CODE,PACKET FORWARD MODE CONFIGURATION
Forwarding Mode
Active Network Mode
// SYSTEM TYPE CONFIGURATION
RADIO-INDEX 1
Radio Mode
Active Mode
Supported Radio Modes
Supported Frequency Domains
Frequency Domain
Active Frequency Domain
1.5.4.2 DHCP
When DHCP Server status is enabled, the DHCP server allocates IP addresses to hosts on the Ethernet side of the BSU or SU.
After adding entries, you must commit and reboot the device for the values take effect.
NOTE: To enable DHCP Server on the device, at least one interface must be enabled in the DHCP Interface Table. To
enable DHCP Server on an interface, at least one pool must be configured for it.
Tsunami MP-8100 Reference Manual
Country Code Configuration
Configure the Frequency Domain
Network mode of the Device
: bridge
: bridge
//
: EndPointA
: EndPointA
: EndPointA<4>,EndPointB<5>
: 4,9,10,11,13,14,15,6,7,8,12,5
: taiwan5ghz
: taiwan5ghz
Command Line Interface
//
22