Proxim Tsunami MP-8100 Series Reference Manual page 40

System Name(config-vlan)# config-table
System Name(config-vlan-configtbl)# rowedit 1 vlan-mode access
Note: Vlan Mode can be configured as Access only when Device is running in SU
mode.Transparent & Trunk Mode can be configured in both BSU &
Access Vlan Id & Access Vlan Priority are Access Mode Related Parameters.The Commands for
these parameters are as follows:
System Name(config-vlan-configtbl)# rowedit 1 access-vlan-id 23
System Name(config-vlan-configtbl)# rowedit 1 access-vlan-priority 3
Command For Configuring Untagged Frames:
System Name(config-vlan-configtbl)# rowedit 1 untagged-frames 1
Similarly the Parameters can be configured on Ethernet Interface 2 by mentioning interface
number as 2 :
For Example :
The following Command is for configuring vlanmode on Ethernet Interface 2:
System Name(config-vlan-configtbl)# rowedit 2 vlan-mode access
System Name# show vlan
// VLAN CONFIGURATION //
Vlan Status
MgmtVlan Id
MgmtVlan Priority
//
INDEX 1
Vlan Mode
Access Vlan ID
Access Vlan Priority
Allow Untagged Frames
Transparent Mode
System Name(config-vlan-configtbl)# rowedit 1 vlan-mode transparent
Trunk Mode & VLAN Trunk Table
System Name(config-vlan-configtbl)# rowedit 1 vlan-mode trunk
The following commands are used to configure the VLAN Trunk table. It is configurable only in bridge mode.
For Ethernet Interface 1
System Name(config)# vlan
System Name(config-vlan)# trunk-table
System Name(config-vlan-trunk)# rowadd 1 secondary-index 0 entry-status create
System Name(config-vlan-trunk)# rowadd 1 secondary-index 0 trunk-id 10
System Name(config-vlan-trunk)# rowadd 1 secondary-index 0 entry-status create
Tsunami MP-8100 Reference Manual
: enable
: 234
: 0
VLAN Ethernet Configuration //
: access
: - 23
: 3
: enable
Command Line Interface
SU modes
40