Proxim Tsunami MP-8100 Series Reference Manual page 39

Mac Acl Address Table
System Name(config)# macacl
System Name(config-macacl)# address-table
System Name(config-macacl-address)# rowadd 1 secondary-index 0 entry-status enable
System Name(config-macacl-address)# rowadd 1 secondary-index 0 comment firstrow
System Name(config-macacl-address)# rowadd 1 secondary-index 0 mac-address
00:11:22:33:44:55
System Name(config-macacl-address)#exit
System Name(config-macacl)#exit
System Name(config)#exit
System Name# show macacl address-table
// MAC ACL ADDRESS TABLE CONFIGURATION //
INDEX 1.1
Mac Address
Comment
Entry Status
1.5.4.9 VLAN
VLANs can operate in different modes based on the incoming traffic. Enter the following commands to configure the VLAN
parameters.
System Name(config)# vlan
System Name(config-vlan)# ?
Possible completions:
config-table
exit
mgmt-vlan-id
mgmt-vlan-priority
trunk-table
vlan-status
System Name(config-vlan)# mgmt-vlan-id
System Name(config-vlan)# vlan-status enable
System Name(config-vlan)# mgmt-vlan-priority 0
Vlan config table
Enter the following commands to configure the VLAN configuration table.
Access Mode
Note: The following Commands are done For Ethernet Interface 1.
Tsunami MP-8100 Reference Manual
: 00:11:22:33:44:55
: firstrow
: enable
Vlan Config Table Configuration
Exits Back to Global Configure Mode
Management VLAN Identifier
Management VLAN priority
VLAN trunk parameters for ethernet interface
Configure the VLAN functionality
234
Command Line Interface
39